Разное

mwz · Отправлено: **10:58, 15-08-2016** | #2

Цитата dascon:

в диспетчере устройств присутствует "HP Smart Array B110i SATA RAID Controller". »

В мануале на который указаны SATA и SAS.

Ment69 · Отправлено: **11:31, 15-08-2016** | #3

dascon, Судя по:

Non-Hot Plug SATA
HP Smart Array B110i SATA RAID Controller
NOTE: To enable RAID for embedded SATA controller, use EZ set-up CD to download driver, hpahcisr.sys, is part of the 8.20 PSP, Smart Start, EZSetup CD. For more information on Smart Array B110i, go to: www.hp.com/go/sataraid
Cold Plug SATA Models
HP Smart Array B110i SATA RAID Controller
NOTE: Supported on LFF models only.

Hot Plug SATA/SAS
HP Smart Array P410 Controller (RAID 0/1/1+0)
HP Smart Array P410 Controller 256 BBWC (RAID/0/1/1+0/5/5+0)
NOTE: Transfer rate: up to 3 Gb/s SATA, up to 6 Gb/s SAS.
HP Smart Array B110i SATA RAID Controller
NOTE: Hot plug functionality requires the addition of a Smart Array Advanced Pack License Key upgrade (P/N TC421A)
NOTE: To enable RAID for embedded SATA controller, use EZ set-up CD to download driver, hpahcisr.sys, is part of the 8.20 PSP, Smart Start, EZSetup CD. For more information on Smart Array, go to: www.hp.com/go/sataraid
NOTE: A diskette drive or virtual FDD using LO100 Advanced Pack is needed to install storage controller drivers during a Windows operating system installation from a CD.
NOTE: Addition of the battery backed cache upgrade enables BBWC, RAID 5, 5+0, array expansion, logical drive extension, RAID migration, and stripe size migration.
NOTE: RAID 6 functionality requires the addition of Smart Array Advanced Pack (P/N: 516471-B21).
NOTE: HP Smart Array B110i does not support greater than 2TB hard drive.

В данном сервере в базовой конфигурации только SATA!

dascon · Отправлено: **11:33, 15-08-2016** | #4

непонятно в мануале указано. Вот здесь получается, что для SAS должен быть другой контроллер - Smart Array P410

Цитата:

В данном сервере в базовой конфигурации только SATA!

я так и подумал... ((