[Kirill_S]

When the printer is in the Ready state, press and hold the GO button for 5 seconds (Большая кнопка с галочкой V). The
Network Configuration page automatically prints with the printer Configuration page.
Note To reset the networking card, when the printer is turned off, press and hold the Reset button
located on the back of the printer. While holding down the Reset button, turn on the printer,
and continue to hold the Reset button until the printer is in the Ready state.

The Network Configuration page provides information about the printer's network
configuration, including the IP address, firmware revision, network statistics, protocol
information, and so on. The Network Configuration page automatically prints when a
Configuration page is printed from the control panel.

Using the hp toolbox
The HP toolbox is a Web application that you can use for the following tasks:
● Check the printer status.
● Configure the printer settings.
● View troubleshooting information.
● View online documentation.
You can view the HP toolbox when the printer is directly connected to your computer or
when using a supported network connection. You must have performed a complete software
installation to use the HP toolbox