Цитата ba1amut:
|
Translation/max. LBA mode ?/48-bits »
|
Посмотрел... Ничего особо плохого не усмотел, кроме
? вместо
LBA.
См. Device information [WDC WD1002FAEX-00Z3A0] для сравнения ниже во вложении . Это тоже хард WDC пусть он чёрный и на 1TB, но они примерно в одно время с ушастым [WDC WD20EARS-00MVWB0] выпущены.
Скрытый текст
********************************************************************************
HDAT2 v5.3 (c) 2016 CBL 14.03.2017 21:24:01
********************************************************************************
Device information [WDC WD1002FAEX-00Z3A0]
********************************************************************************
--------------------------------------------------------------------------------
Source Cylinders Heads Sectors Total sectors Size
--------------------------------------------------------------------------------
ATA LBA28 16383 16 63 268435455 137.44 GB
ATA LBA48 1953525168 1.00 TB
ATA CHS 16383 16 63 16514064 8.46 GB
INT13h/BIOS 1024 255 63 16450560 8.42 GB
*Ext.INT13h 16383 16 63 1953525168 1.00 TB
(* = CHS parameters are not valid)
--------------------------------------------------------------------------------
SET MAX size 1953525168 1.00 TB
DCO size 1953525168 1.00 TB
--------------------------------------------------------------------------------
Device model [SATA/SATA] WDC WD1002FAEX-00Z3A0
Vendor Western Digital
Translation/max. LBA mode LBA/48-bits
Logical sector size [b] 512
Physical sector size [b] 512
Detect mode PCI
Removable device NO
ATA I/O port Base/Control/IRQ 8000h/7C02h/14
--------------------------------------------------------------------------------
ATA/ATAPI Identify Device
--------------------------------------------------------------------------------
Integrity word (optional)
-> Signature: O.K. [reported A5h, should be A5h]
-> Checksum : O.K. [reported 6Fh, should be 6Fh]
ATA major version 01FEh
-> ATA/ATAPI 1 2 3 4 5 6 7 8
ATA minor version 0000h
-> not reported
Transfer mode: max. supported Ultra DMA 6/ATA133
Transfer mode: selected Ultra DMA 5/ATA100
Serial number WD-WCATR4929657
Firmware 05.01D05
Cache n/a or greater than 32 MB
-> Cache type: not specified
General configuration 427Ah = 0100001001111010b
-> Protocol type: ATA
Specific configuration C837h
-> Device does not require SET FEATURES subcommand to spin-up after power-up
and IDENTIFY DEVICE response is complete.
Maximum queue depth 32
COMRESET result 0000h = 0000000000000000b
Detected an 80-conductor cable NO
Multiword DMA transfer cycle time per word [ns]
-> Minimum: 120
-> Vendor's recommended: 120
Minimum PIO transfer cycle time [ns]
-> without IORDY flow control: 120
-> with IORDY flow control: 120
Security status 0029h = 0000000000101001b
-> Security: supported
-> Device: frozen
-> Security: disabled
-> Enhanced Security Erase: supported
Master password identifier (Revision code) FFFEh
-> Master password identifier feature is supported
Time for normal security erase unit 160 min.
Time for enhanced security erase unit 160 min.
Extended number of user addressable sectors reserved
--------------------------------------------------------------------------------
Capabilities
-> DMA supported
-> LBA supported
-> IORDY may be disabled
-> IORDY supported
-> Standby timer values are supported
-> Vendor specific Standby timer value minimum
--------------------------------------------------------------------------------
Command/Feature Sets supported ENABLED
--------------------------------------------------------------------------------
SMART feature set YES
Security feature set NO
Power management feature set YES
Write cache YES
Read cache (look-ahead) YES
Host Protected Area (HPA) feature set YES
WRITE BUFFER command YES
READ BUFFER command YES
NOP command YES
DOWNLOAD MICROCODE command YES
Power-Up In Standby (PUIS) feature set NO
SET FEATURES required to spinup after power-up YES
SET MAX security extension NO
Automatic Acoustic Management (AAM) feature set NO
48-bit address feature set YES
Device Configuration Overlay (DCO) feature set YES
FLUSH CACHE command YES
FLUSH CACHE EXT command YES
SMART error logging YES
SMART self-test YES
General Purpose Logging (GPL) feature set YES
World Wide Name (WWN) YES
READ/WRITE LOG DMA EXT command YES
DOWNLOAD MICROCODE command with offsets (mode 3) YES
Long Logical Sector (LLS) feature set NO
Long Physical Sector (LPS) feature set NO
--------------------------------------------------------------------------------
Advanced Power Management (APM) level value 00h
Acoustic Management (AAM): vendors/current value 80h/FEh
Read/Write LONG: ECC bytes 50
Read/Write MULTIPLE: sectors per DRQ data block
-> Maximum: 16
-> Current: 16
--------------------------------------------------------------------------------
Streaming
--------------------------------------------------------------------------------
-> not supported
--------------------------------------------------------------------------------
Logical/Physical blocks
--------------------------------------------------------------------------------
Logical/Physical sector size word [not valid] 0000h
Logical sector size [b] 512
Logical sector zero offset not valid
Long Physical Sector (LPS) Alignment Error reporting
-> not supported
--------------------------------------------------------------------------------
Inter-seek delay for acoustic testing [microsec] 0
Command Completion Time Limit (CCTL) [ms] 0
-> TLC feature set is not supported.
CFA power mode not supported
Current media serial number
-> not supported
Free-fall control sensitivity not supported
Number of data blocks per DOWNLOAD MICROCODE mode 3
-> The DOWNLOAD MICROCODE command supports the offset transfer method.
-> Minimum: 1 = 512 bytes
-> Maximum: 4096 = 2097152 bytes
Transport major revision number: support
-> Serial: SATA rev.2.6
-> Serial: SATA rev.2.5
-> Serial: SATA II Extensions
-> Serial: SATA 1.0a
Transport minor revision number not reported
SMART Command Transport (SCT) command set
-> SCT supported
-> Long Sector Access (Read/Write Long)
-> LBA Segment Access (Write Same)
-> Feature Control
-> Data Tables
-> vendor specific
-> vendor specific
Trusted Computing feature (TCG) not valid
Nominal media rotation rate [rpm] not reported
Device Nominal Form Factor not reported
DATA SET MANAGEMENT
-> The Trim function is not supported.
DATA SET MANAGEMENT: max. number of blocks of LBA range entries
-> not supported
Additional Product Identifier not supported
--------------------------------------------------------------------------------
NV Cache
--------------------------------------------------------------------------------
-> not supported
--------------------------------------------------------------------------------
SATA capabilities supported
--------------------------------------------------------------------------------
1.5 Gb/s (SATA GEN1)
3.0 Gb/s (SATA GEN2)
6.0 Gb/s (SATA GEN3)
Native Command Queuing (NCQ)
Host Initiated Link Power Management (HIPM)
Phy Event Counters log
NCQ priority information
Current SATA speed: not supported
--------------------------------------------------------------------------------
SATA features supported ENABLED
--------------------------------------------------------------------------------
DMA setup FIS Auto-Activate optimization NO
Software Settings Preservation (SSP) YES
--------------------------------------------------------------------------------
Extended INT13h
--------------------------------------------------------------------------------
Extended INT13h support YES
Major/Vendor/Extension Version 3.0/0.0/0.0
-> EDD v2.0
Subset
-> Fixed disk access subset: YES
-> Device locking and ejecting subset: NO
-> Enhanced Disk Drive (EDD) subset: YES
-> 64-bit extension: NO
INT13h Identify Device support not detected
--------------------------------------------------------------------------------
Device Parameter Table (DPT)
--------------------------------------------------------------------------------
Information flags
-> Bits 4-6 are not valid
Block size [b] 512
DPT Extension (DPTE) pointer EAECh:4E80h
Key to presence of Device Path (BEDDh) BEDDh
Checksum for Device Path Information
-> O.K. [reported 73h, should be 73h]
Length of Device Path [b] 44
Host bus type PCI
Interface type SATA
Interface Path for bus type PCI
-> hex dump = [ 00 1F 02 00 00 00 00 00 ]
-> Bus = 0
-> Slot = 31
-> Function = 2
-> Channel = 0
Device Path for interface type SATA
-> hex dump = [ 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ]
-> ATA device = 0
-> SATA device = 0
--------------------------------------------------------------------------------
Device Parameter Table Extension (DPTE)
--------------------------------------------------------------------------------
Version 1.1 [11h]
Checksum
-> O.K. [reported 5Ah, should be 5Ah]
I/O Port base address 8000h
Control Port address 7C02h
IRQ 14
Head register upper nibble
-> ATA DEV = Master
-> LBA enable = YES
BIOS Vendor specific 00h
ATA READ/WRITE MULTIPLE Block Count 16
DMA information 00h
-> DMA channel = 00h
-> DMA type = 00h
PIO information 04h
-> PIO type = 04h
BIOS selected HW specific option flags
-> Fast PIO access
-> READ/WRITE MULTIPLE access
-> LBA translation
-> 32-bit transfer mode
-> Bit-shift translation
--------------------------------------------------------------------------------
Добавлено...
=========
Цитата Normal:
|
Вот надо "убить" это DCO »
|
А у меня тоже енто DCO на ВЕСЬ объём есть, ---- посмотрите... И ничего...
