[vainkop]

Про CD и не должно говориться, в те времена для этого использовали дискеты. Да и вроде это уже не первый контроллер, который я с диска с досом обновляю, тут всё должно быть ок.

ASM сегодня попробую, но учитывая, что ifu и acu тоже на контроллер неадекватно реагируют надежды мало

В мануале про Resetting the Controller как раз и сказано про mode 0 и т.д., что я и проделал.

Resetting the Controller
This section explains how to reset (or flash) your Adaptec RAID controller. You may want to do
this if the controller becomes inoperable, or if a firmware upgrade is unsuccessful.
To reset your Adaptec RAID controller:
1 Download the firmware version currently installed on your controller from
www.adaptec.com
2 Extract the downloaded files to a folder on your local hard drive (for example,
C:\Download\Drivers).
3 Create a bootable MS–DOS floppy disk and copy the AFU.exe file to it. Copy the first
firmware image to the same floppy disk.
4 Create additional bootable MS–DOS floppy disks and copy each additional firmware
image to its own floppy disk.
5 Power off your computer, disconnect the power cord, then open the cabinet following the
manufacturer’s instructions.
6 Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
flash connector. (To locate the Mode 0 flash connector on your Adaptec RAID controller,
see the figures in About Your RAID Controller on page 15.)
7 Reconnect the power cord, power on your computer, then boot to the floppy disk
containing the AFU.exe file (see Step 3).
8 At the prompt, type a:\afu update /c x
where x is the controller number.
9 Insert the other floppy disks when prompted.
10 When the flash is complete, power off your computer, disconnect the power cord, then
remove the jumper.
11 Close the computer cabinet, reconnect the power cord, then power on your computer.
The controller should boot correctly